Evaluación de la influencia del poliestireno en el desarrollo de la resistencia a la compresión, peso específico y conductividad térmica para un concreto de diseño F`C=210KG/cm2 respecto a un concreto patrón.
View/ Open
Date
2017-06-12Author
Gastañaga Flores, Fernando
Huamán Merma, José Cristhian
Advisor
Chacón Sánchez, Víctor
Metadata
Show full item recordAbstract
La presente investigación tiene como objetivo analizar la influencia del poliestireno en el concreto en las propiedades de resistencia a la compresión,
peso específico y conductividad térmica.
Para esto se utilizó testigos de concreto, los cuales fueron fabricados con agregados finos de las canteras Mina Roja y Cunyac, agregado grueso de la
cantera Vicho, cemento Yura Tipo IP, perlas de poliestireno de un diámetro de
0.3 – 3mm; el diseño de mezclas para las briquetas de concreto fue calculado
bajo los parámetros de la norma ACI 211.1 para un diseño de f’c=210kg/cm. Las briquetas de concreto fueron ensayadas a 7, 14 y 28 días para los ensayos de resistencia a la compresión y peso específico, los testigos de conductividad
térmica fueron ensayados solo a los 28 días y tienen una medida de 10cm de
diámetro por 10 cm de altura. Se utilizaron proporciones de 10%, 20%, 30%,
40% y 50% de poliestireno sustituyendo al agregado grueso.
Se pudo apreciar que al agregar poliestireno a la mezcla de concreto se reduce
el peso específico del concreto y la conductividad térmica del concreto, pero se
ve afectada la resistencia a la compresión cuanto más poliestireno se añade a la mezcla. Los mejores resultados se observaron en las dosificaciones de 10% de poliestireno sustituyendo al agregado grueso, al 10% de poliestireno sustituyendo al agregado grueso se obtuvo una disminución del 3.61% del peso
específico respecto al concreto patrón y una disminución del 13.68% de la conductividad térmica. The present research aims to analyze the influence of polystyrene on concrete in the properties of compressive strength, specific gravity and thermal conductivity.
For this concrete witnesses were used, which were manufactured with fine aggregates of the quarries Mina Roja and Cunyac, aggregate coarse of the quarry Vicho, cement Yura Type IP, polystyrene beads of a diameter of 0.3 –
3mm; The design of blends for concrete briquettes was calculated under the
parameters of ACI 211.1 for a design of f'c = 210 kg / cm2.
The concrete briquettes were tested at 7, 14 and 28 days for the tests of resistance to compression and specific weight, the thermal conductivity tests
were tested only at 28 days and have a measurement of 10cm in diameter by
10cm in height . Proportions of 10%, 20%, 30%, 40% and 50% of polystyrene
were used replacing the coarse aggregate.
It could be seen that adding polystyrene to the concrete mix reduces the specific weight of the concrete and the thermal conductivity of the concrete, but the compressive strength is affected as more polystyrene is added to the mixture.
The best results were observed in the dosages of 10% of polystyrene replacing
the coarse aggregate, at 10% of polystyrene replacing the coarse aggregate
obtained a decrease of 3.61% of the specific weight with respect to the standard concrete and a decrease of 13.68% of the thermal conductivity.